Q. A system with a double pole at the origin is unstable since the corresponding term in the time domain

View solution

Q. To increase the speed of response of a pressure spring liquid or gas expansion thermometer, the clearance space between the thermometer bulb and the thermal well should not be filled with

View solution

Q. In a second order under damped system, the

View solution

Q. In an exothermic chemical reactor, the manipulated variable is the flow rate of

View solution

Q. Very low pressure is expressed in microns(μ), which is equal to __________ mm of Hg coloumn (absolute) at 0°C.

View solution

Q. Which of the following is not a second order instrument ?

View solution

Q. Small furnace draught is accurately measured by an inclined tube manometer, in which the manometric liquid used most commonly is

View solution

Q. Specific conductance is defined as the reciprocal of resistance in ohms of 1c.c. of liquid at a specified temperature. Its value for distilled water is about __________ micro mho/cm³.

View solution

Q. A simple pitot tube measures the

View solution

Q. For a feed back control system to be stable, the

View solution

Q. __________ is the static characteristics of an instrument,

View solution

Q. Phase lag of the frequency response of a second order system to a sinusoidal forcing function

View solution

Q. Dead zone in an instrument must be less than __________ percent of the scale.

View solution

Q. Emission spectroscopy is used for

View solution

Q. A mercury thermometer can not be used to measure the temperature below the freezing point of mercury, which is __________ °C.

View solution

Q. __________ controller has the maximum stabilising time.

View solution

Q. Out of the following temperature measuring instruments, the measurement accuracy will be minimum for the

View solution

Q. Stalagmometer is used for the measurement of

View solution

Q. The deflection in diaphragm (which is used as pressure sensor in pneumatic and electronic instruments) is dependent on the metal thickness, its diameter (d) and shape & number of corrugations. Its deflection is proportional to

View solution

Q. Thermal conductivity cell is the primary element of a/an __________ analyser.

View solution