Q. The type of spillway which is provided on narrow valleys where no side flanks are available is ____________________

View solution

Q. Which of the following curve is provided when the slope of the chute changes from milder to steeper?

View solution

Q. Calculate the freeboard for the top levels of the side walls if the mean velocity of water in the chute reach is 3.5 m/s and the mean depth of water in the chute reach under consideration is 4.7 m.

View solution

Q. The minimum slope of the chute is governed by the condition that _____________

View solution

Q. What is the approximate percentage of light reinforcement that is provided in the top of the reinforced concrete slabs at the base?

View solution

Q. A shaft spillway is located _______________________

View solution

Q. The siphons installed within a gravity dam to spill the surplus reservoir water are known as ______________________

View solution

Q. The siphons installed over overflow dams constitute what are known as __________________

View solution

Q. The only spillway among the following through which the discharge does not increase as fast as it increases in all others is _________________

View solution

Q. The only spillway among the following through which the discharge is almost at its capacity rate even from the start of its functioning is ________________

View solution

Q. An air vent is provided at FRL to break the siphoning action at that level in a ___________________

View solution

Q. Which of the following spillway is designed in India by Ganesh Iyer?

View solution

Q. The crest of a siphon spillway is fixed at ________________

View solution

Q. A siphon spillway is sufficiently independent of the water surface elevation of the reservoir.

View solution

Q. The allowable maximum negative head on an average is equal to __________

View solution

Q. The structure which is not used in a shaft spillway is ________________

View solution

Q. Morning glory is the _____________________________

View solution

Q. For a saddle siphon, the maximum operative head is 4.53 m. The width and height of the throat of the siphon are 5 m and 2.25 m respectively. The coefficient of discharge is 0.90. How many units are required to pass a flood of 350 cumecs? (Assume g = 10 m/s2)

View solution

Q. A siphon spillway in a concrete gravity dam is in the shape of ________________

View solution

Q. The energy dissipation at the toe of the spillway is affected basically by the use of hydraulic jump in _______________________

View solution