Q. Vertical stirrups are a form of _______ reinforcement.

View solution

Q. The shear to be resisted by shear reinforcement is given by ___________

View solution

Q. The shear resistance of bent up bars shall not exceed __________ the total shear to be resisted.

View solution

Q. What is the horsepower of the engine if the power is 219324 W.

View solution

Q. A lift carry 10 persons each weighing 60 kg to the top storey of the building 100 m height. Calculate the potential energy acquired by the person.

View solution

Q. Calculate the maximum shear stress of a circular beam of 100 mm diameter, if the average shear stress is 0.63 N/mm².

View solution

Q. Calculate the nominal shear stress, if a singly reinforced rectangular beam 230×450 mm effective depth is subjected to a factored load of 60 kN.

View solution

Q. The minimum shear reinforcement is given by Asv/bSv = _______

View solution

Q. Bent up bars do not resist diagonal tension.

View solution

Q. The ultimate shear force at a section of an RCC beam is 300 kN. The shear resisted by concrete is 77.5 kN. What is the shear for which shear reinforcement is required?

View solution

Q. Bond stress is a stress acting ___________ to the bar on the interface between reinforcement and concrete.

View solution

Q. ________ is developed due to adhesion between concrete and steel.

View solution

Q. Bond is developed due to _________

View solution

Q. ___________ depends on grade of concrete and diameter of bar etc.

View solution

Q. Which of the following bond is also known as a local bond?

View solution

Q. _____________ bond arises when bar carrying certain force is terminated.

View solution

Q. The development length can be determined easily by _______ test.

View solution

Q. To improve the anchorage of bars ______ are provided in plain bars.

View solution

Q. In case of HYSD bars ___________ are provided to increase anchorage length.

View solution

Q. Polar moment of inertia is denoted by ___________

View solution