Q. Calculate the moment of inertia of a hollow circular section whose external diameter is 60 mm and thickness is 5 mm about centroidal axis.

View solution

Q. The effect of ___________ holes is to reduce the strength of connected plates.

View solution

Q. A cylinder section having no __________ is known as seamless section.

View solution

Q. A water main of 1 m in diameter and 25 mm thick is subjected to an internal pressure of 2.5 N/mm². Calculate the longitudinal stress induced.

View solution

Q. What is the design Bond stress in plane bars intention for m25 grade concrete?

View solution

Q. The value of design Bond stress in plain bars will increase in compression by __________

View solution

Q. What is the anchorage value of standard “U” type hook?

View solution

Q. The flexural bond is _________ at the section.

View solution

Q. _________ reinforcement is designed for sections where the bending moment is maximum.

View solution

Q. In case of __________ beams, the 50% of bars are curtailed at a distance of 0.5 ×l.

View solution

Q. Splices are provided when the ________ bar available is less than that required.

View solution

Q. Lap splices should not be used for bars larger than __________ mm.

View solution

Q. Cantilever slab is categorised based on support conditions.

View solution

Q. According to IS 456: 2000; the span to depth ratio of a simply supported beam is ___________

View solution

Q. The __________ of the slab is governed by span to depth ratio.

View solution

Q. The material does not possessing any kind of elastic symmetry, then the material is said to be _______

View solution

Q. What is the ratio of maximum deflection to maximum bending stress if a simply supported rectangular beam of span “L” and it carries a central load W.

View solution

Q. In a cantilever of span subjected to a point load of w acting at a distance of (1/3) L from free end. The deflection under load will be

View solution

Q. The slabs whose corners are prevented from lifting are known as _________

View solution

Q. As the corners are held down ___________ reinforcement has to be provided at the corners.

View solution