Question
a.
Higher is the temperature of the radiating body, higher is the wavelength of radiation.
b.
Logarithmic mean area is used for calculating the heat flow rate through a thick walled cylinder.
c.
The wavelength corresponding to maximum mono-chromatic emissive power increases with rise in temperature.
d.
Solid angle subtended by the finite surface at the radiating element is called the angle of incidence.
Posted under Heat Transfer Basics Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Pick out the correct statement.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a shell and tube type heat exchanger, the floating tube bundle heat arrangement is used
View solution
Q. Stefan-Boltzman law applies to __________ body.
View solution
Q. The film co-efficient is decreased due to the presence of non-condensing gases in the vapors. The film co-efficient of superheated vapor as compared to that of saturated vapor is
View solution
Q. Planck's distribution law is valid for __________ bodies.
View solution
Q. For hot feed, forward feeding as compared to backward feeding results in __________ economy.
View solution
Q. Radiation energy is emitted by all the substances, which are above
View solution
Q. Which one gives the monochromatic emissive power for black body radiation ?
View solution
Q. For what value of Prandtl number, St = f/2?
View solution
Q. In a shell and tube heat exchanger,
View solution
Q. Dietus-Boelter equation used for the determination of heat transfer co-efficient is valid
View solution
Q. The range of electromagnetic spectrum important in heat transfer by radiation is __________ microns.
View solution
Q. Use of transverse baffles in a shell and tube heat exchanger is done to increase the
View solution
Q. The actual temperature drop across the heating surface of an evaporator depends on the
View solution
Q. Economy of a multiple effect evaporator depends upon the
View solution
Q. For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it
View solution
Q. When vaporisation takes place through a blanketting film of gas, the phenomenon is termed as __________ boiling.
View solution
Q. Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter)
View solution
Q. Stefan-Boltzman law which describes the radiation heat transfer states that, it is proportional to (where, t = temperature in °C, T = absolute temperature in ° K )
View solution
Q. The Nusselt number for fully developed (both thermally and hydrodynamically) laminar flow through a circular pipe, where the wall heat flux is constant, is
View solution
Q. Among liquids, water has a comparatively high value of thermal conductivity, due to its
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
