Q. For what value of Prandtl number, St = f/2?

View solution

Q. In a shell and tube heat exchanger,

View solution

Q. Dietus-Boelter equation used for the determination of heat transfer co-efficient is valid

View solution

Q. The range of electromagnetic spectrum important in heat transfer by radiation is __________ microns.

View solution

Q. Use of transverse baffles in a shell and tube heat exchanger is done to increase the

View solution

Q. The actual temperature drop across the heating surface of an evaporator depends on the

View solution

Q. Economy of a multiple effect evaporator depends upon the

View solution

Q. For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it

View solution

Q. When vaporisation takes place through a blanketting film of gas, the phenomenon is termed as __________ boiling.

View solution

Q. Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter)

View solution

Q. Stefan-Boltzman law which describes the radiation heat transfer states that, it is proportional to (where, t = temperature in °C, T = absolute temperature in ° K )

View solution

Q. The Nusselt number for fully developed (both thermally and hydrodynamically) laminar flow through a circular pipe, where the wall heat flux is constant, is

View solution

Q. Among liquids, water has a comparatively high value of thermal conductivity, due to its

View solution

Q. Reynold's analogy states that (where, St = Stanton number f = friction factor)

View solution

Q. For evaporation of viscous solution in a multiple effect evaporator, the prefered feeding scheme is

View solution

Q. The sum of reflectivity and absorptivity for an opaque body is equal to

View solution

Q. The film thickness for laminar film condensation on vertical surface __________ from top to bottom.

View solution

Q. What is the steam economy in case of a single effect evaporator system ?

View solution

Q. If average heat transfer co-efficient is ha and the local coefficient at the end of the plate is hl then in case of heat transfer to a fluid flowing over a flat plate, heated over its entire length

View solution

Q. jH factor for heat transfer is not a function of the __________ number.

View solution