Q. Stefan-Boltzman law which describes the radiation heat transfer states that, it is proportional to (where, t = temperature in °C, T = absolute temperature in ° K )

View solution

Q. The Nusselt number for fully developed (both thermally and hydrodynamically) laminar flow through a circular pipe, where the wall heat flux is constant, is

View solution

Q. Among liquids, water has a comparatively high value of thermal conductivity, due to its

View solution

Q. Reynold's analogy states that (where, St = Stanton number f = friction factor)

View solution

Q. For evaporation of viscous solution in a multiple effect evaporator, the prefered feeding scheme is

View solution

Q. The sum of reflectivity and absorptivity for an opaque body is equal to

View solution

Q. The film thickness for laminar film condensation on vertical surface __________ from top to bottom.

View solution

Q. What is the steam economy in case of a single effect evaporator system ?

View solution

Q. If average heat transfer co-efficient is ha and the local coefficient at the end of the plate is hl then in case of heat transfer to a fluid flowing over a flat plate, heated over its entire length

View solution

Q. jH factor for heat transfer is not a function of the __________ number.

View solution

Q. The Fourier number (defined as a.t/L²) is used in the analysis of problem involving heat transfer by

View solution

Q. The energy radiated from a surface Q at absolute temperature T is related as

View solution

Q. A 2-4 heat exchanger involves

View solution

Q. In a liquid-liquid heat exchanger, for the same process temperature, the ratio of the LMTD in parallel flow to the LMTD in counter flow is always

View solution

Q. With increase in temperature, the thermal conductivity of steel

View solution

Q. Which of the following forced convection heat transfer equation accounts for the liquid viscosity effect for viscous liquids ?

View solution

Q. The main function of baffles provided in a shell and tube heat exchanger is to

View solution

Q. 'Fouling factor' used in the design of a multipass shell and tube heat exchanger is a

View solution

Q. A fluid is flowing inside the inner tube of a double pipe heat exchanger with diameter 'd'. For a fixed mass flow rate, the tube side heat transfer co-efficient for turbulent flow conditions is proportional to

View solution

Q. Prandtl and Reynolds analogy are same, when Prandtl number is

View solution