Question
a.
Packed tower
b.
Bubble-cap plate column
c.
Seive-plate column
d.
Wetted wall column
Posted under Mass Transfer Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Which of the following provides maximum contact surface for a liquid-vapour system?
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. For experimental determination of mass transfer co-efficient by wetted wall tower, the mass transfer area is
View solution
Q. In stripping section of continuous distillation column, the
View solution
Q. In extraction, as the temperature increases, the area of hetrogeneity (area covered by binodal curve)
View solution
Q. Pick out the wrong statement.
View solution
Q. In case of an unsaturated mixture of gas and vapor, the percentage saturation is __________ its relative saturation.
View solution
Q. At constant pressure, with increase of temperature, the dew point will
View solution
Q. For a single component absorber, the operating line is straight only when plotted in term of __________ units.
View solution
Q. Raschig ring made of procelain cannot be used for treating concentrated
View solution
Q. H₂S present in naphtha reformed gas is removed by absorbing with
View solution
Q. During constant rate drying period, vaporisation rate per unit drying surface area
View solution
Q. Pick out the wrong statement.
View solution
Q. In rectifying section of a continuous distillation column, the
View solution
Q. For a distillation column operating at minimum reflux, the
View solution
Q. A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids))
View solution
Q. Flash distillation is suitable for the separation of components
View solution
Q. In Mcabe-Thiele method, at infinite reflux ratio
View solution
Q. Leaching rate is independent of the
View solution
Q. Molality is defined as the number of gm moles of solute per __________ of solvent.
View solution
Q. __________ is concerned with the adsorption equilibria.
View solution
Q. Fractional solvent extraction
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
