Q. The incident optical power required to achieve a desirable SNR is 168.2 nW. What is the value of incident power in dBm?

View solution

Q. In the equation given below, what does τ stands for?

Zₘ = ηP₀τ/hf

View solution

Q. Which are the two main sources of noise in photodiodes without internal gain?

View solution

Q. The dominating effect of thermal noise over the shot noise in photodiodes without internal gain can be observed in wideband systems operating in the range of ________

View solution

Q. A silicon p-i-n photodiode incorporated in an optical receiver has following parameters:

Quantum efficiency = 70%
Wavelength = 0.8 μm
Dark current = 3 nA
Load resistance = 4 kΩ
Incident optical power = 150 nW.
Bandwidth = 5 MHz

Compute the photocurrent in the device.

View solution

Q. In a silicon p-i-n photodiode, if load resistance is 4 kΩ, temperature is 293 K, bandwidth is 4 MHz, find the thermal noise in the load resistor.

View solution

Q. ________________ is a combination of shunt capacitances and resistances.

View solution

Q. ______________ is used in the specification of optical detectors.

View solution

Q. A photodiode has a capacitance of 6 pF. Calculate the maximum load resistance which allows an 8MHz post detection bandwidth.

View solution

Q. The internal gain mechanism in an APD is directly related to SNR. State whether the given statement is true or false.

View solution

Q. ____________ is dependent upon the detector material, the shape of the electric field profile within the device.

View solution

Q. For silicon APDs, the value of excess noise factor is between _________

View solution

Q. __________ determines a higher transmission rate related to the gain of the APD device.

View solution

Q. _________________ APDs are recognized for their high gain-bandwidth products.

View solution

Q. APDs do not operate at signal wavelengths between 1.3 and 1.6 μm.

View solution

Q. How many circuits are present in an equivalent circuit for the digital optical fiber receiver?

View solution

Q. __________ compensates for distortion of the signal due to the combined transmitter, medium and receiver characteristics.

View solution

Q. ____________ is also known as frequency-shaping filter.

View solution

Q. The phase frequency response of the system should be ____________ in order to minimize inter-symbol interference.

View solution

Q. Noise contributions from the sources should be minimized to maximize the receiver sensitivity.

View solution