Q. A high-input-impedance amplifier has following parameters (Total effective load resistance = 2 MΩ, Temperature = 300 K). Find the mean square thermal noise current per unit bandwidth for the high-impedance configuration.

View solution

Q. The mean square thermal noise current in the trans-impedance configuration is _________ greater than that obtained with the high-input-impedance configuration.

View solution

Q. The major advantage of the trans-impedance configuration over the high-impedance front end is ______________

View solution

Q. The trans-impedance front end configuration operates as a __________ with negative feedback.

View solution

Q. ____________ is the lowest noise amplifier device.

View solution

Q. FET device has extremely high input impedance greater than _________

View solution

Q. The properties of a bipolar transistor are superior to the FET.

View solution

Q. Bipolar transistor is more useful amplifying device than FET at frequencies _____________

View solution

Q. High-performance microwave FETs are fabricated from ___________

View solution

Q. Gallium arsenide MESFETs are advantageous than Silicon FETs.

View solution

Q. The PIN-FET hybrid receivers are a combination of ______________

View solution

Q. PIN-FET hybrid receiver is designed for use at a transmission rate of _____________

View solution

Q. It is difficult to achieve higher transmission rates using conventional __________

View solution

Q. Which receiver can be fabricated using PIN-FET hybrid approach?

View solution

Q. A silicon p-i-n photodiode utilized with the amplifier and the receiver is designed to accept data at a rate of ___________

View solution

Q. What is usually required by FETs to optimize the figure of merit?

View solution

Q. How many design considerations are considered while determining the receiver performance?

View solution

Q. FET preamplifiers provide higher sensitivity than the Si-bipolar device.

View solution

Q. What is the abbreviation of HBT?

View solution

Q. What type of receivers are used to provide wideband operation, low-noise operation?

View solution