Question
a.
Work output of turbine is very large than work input to the pump
b.
Work output of turbine is very small than work input to the pump
c.
Work output of turbine is equal to work input to the pump
d.
None of the mentioned
Posted under Power Plant Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Steam Power Plants are more popular in electric power generation because ___________
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Which is the most common type of Evaporator?
View solution
Q. In Rankine Cycle, water is converted to saturated liquid in ___________
View solution
Q. If Evaporator & Condenser pressures are p & q, the intercooler pressure P is given as?
View solution
Q. Phase change at constant pressure takes place in _____________
View solution
Q. Which of these factors don’t cause Internal Irreversibility of a Rankine cycle?
View solution
Q. What is the unit of Heat rate?
View solution
Q. Rankine cycle operating on low pressure limit of p1 and high pressure limit of p2 ___________
View solution
Q. Rankine efficiency of a Steam Power Plant ___________
View solution
Q. Rankine cycle comprises of ___________
View solution
Q. In Rankine cycle, the work output from the turbine is given by ___________
View solution
Q. Which of the following contributes to the improvement of efficiency of Rankine cycle in a Thermal Power Plant?
View solution
Q. Match the following:
i) Boiler A. reversible adiabatic expansion of steam
ii) turbine B. constant pressure heat heat addition
iii) Condenser C. reversible adiabatic compression
iv) pump D. constant pressure heat rejection
View solution
Q. What is the actual turbine inlet temperature in Rankine cycle?
View solution
Q. Rankine cycle efficiency of a good Steam Power Plant may be in the range of?
View solution
Q. A simple Rankine cycle operates the Boiler at 3 MPa with an outlet temperature of 350°C and the Condenser at 50 kPa. Assuming ideal operation and processes, what is the thermal efficiency of this cycle?
View solution
Q. A simple Rankine cycle produces 40 MW of power, 50 MW of process heat and rejects 60 MW of heat to the surroundings. What is the utilization factor of this co generation cycle neglecting the pump work?
View solution
Q. A gas turbine works on __________
View solution
Q. What is the range of Thermal efficiency in the Brayton cycle?
View solution
Q. What is the maximum possible TIT(Turbine Inlet Temperature)?
View solution
Q. A simple Brayton cycle uses Helium as the working fluid, has a maximum temperature of 1000 K, and a pressure ratio of 4. At the start of the compression, the Helium pressure and temperature are 50 kPa and 250 K. Based upon cold-air standard analysis assumptions, the thermal efficiency of the cycle is?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Power Plant Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
