Q. Concrete is not recommended to be placed at a temperature below __________ºC.

View solution

Q. IS: 7861 part-2 deals with __________

View solution

Q. Why the time period for removal of form work has to be increased.

View solution

Q. If concrete is exposed to repeated freezing and thawing after the final set, the final qualities of the concrete may also be __________

View solution

Q. Large temperature differentials within the concrete member may promote __________

View solution

Q. When the concrete in fresh stage is exposed to freeze before certain pre-hardening period, compressive strength may get __________

View solution

Q. Concrete is not recommended to be placed at a temperature above _________ºC.

View solution

Q. IS: 7861 part-1 deals with ___________

View solution

Q. A higher temperature of fresh concrete results in a __________ hydration of cement.

View solution

Q. Does this reduce handling time?

View solution

Q. Rapid evaporation may cause plastic shrinkage __________

View solution

Q. It is difficult to retain moisture for hydration for rapid evaporation of water during curing period.

View solution

Q. Prepacked concrete _________ water proofing concrete.

View solution

Q. Cement has ________ % volumetric shrinkage after curing.

View solution

Q. After vacuum mixing, the volumetric shrinkage can be raised from 3–5% to __________ % in different cements.

View solution

Q. Vacuum mixing systems reduce the exposure by _________ %.

View solution

Q. The exposure of conventional mixing in open bowl is about ___________ ppm in the breathing zone.

View solution

Q. The __________ compressive strength required from structural consideration.

View solution

Q. The adequate workability necessary for ___________ compaction with the compacting equipment available.

View solution

Q. ___________ water-cement ratio content to give adequate durability for the particular site conditions.

View solution