Q. In drilling aluminium, a drill with

View solution

Q. Ceramic cutting tools are

View solution

Q. Which of the following statement is correct about hot machining?

View solution

Q. For turning internal tapers, the suitable method is

View solution

Q. Lathe bed is made of

View solution

Q. In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called

View solution

Q. The operation of making a cone-shaped enlargement of the end of a hole is known as

View solution

Q. Which of the following statement is correct in regard to centreless grinding?

View solution

Q. The specific cutting energy used for establishing the machinability of the metal depends upon its

View solution

Q. The form grinding is used to grind gear teeth, threads, splined shafts and holes.

View solution

Q. Which of the following parameters govern the value of shear angle in continuous chip formation?

View solution

Q. The relief or clearance at the cutting edge of a flat drill varies from

View solution

Q. Internal or external threads of different pitches can be produced by

View solution

Q. In a shaper

View solution

Q. Which of the following statement is correct about EDM machining?

View solution

Q. Spot facing is an operation of smoothing and squaring the surface around a hole.

View solution

Q. A better machinable metal is one which gives

View solution

Q. For turning small taper on long workpiece, the suitable method is

View solution

Q. In a milling operation, two side milling cutters are mounted with a desired distance between them so that both sides of a workpiece can be milled simultaneously. This set up is called

View solution

Q. The time (in minutes) for a drilling a hole is given by where h is the

View solution