Q. Spot facing is an operation of smoothing and squaring the surface around a hole.

View solution

Q. A better machinable metal is one which gives

View solution

Q. For turning small taper on long workpiece, the suitable method is

View solution

Q. In a milling operation, two side milling cutters are mounted with a desired distance between them so that both sides of a workpiece can be milled simultaneously. This set up is called

View solution

Q. The time (in minutes) for a drilling a hole is given by where h is the

View solution

Q. Crack in grinding wheel is developed due to

View solution

Q. The average cutting speed for turning mild steel with a high speed steel tool is

View solution

Q. For machining a cast iron workpiece by a high speed steel tool, the average cutting speed is

View solution

Q. The vector sum of cutting velocity and chip velocity is __________ shear velocity.

View solution

Q. For harder alloy steel, the point angle of the drill is kept

View solution

Q. An open structure of a grinding wheel is denoted by the number 1 to 8.

View solution

Q. In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be

View solution

Q. In a shaper, the metal is removed during

View solution

Q. The aluminium oxide abrasive is chiefly used for grinding

View solution

Q. In __________ operation, the chip thickness is minimum at the beginning of the cut and it reaches to the maximum when the cut terminates.

View solution

Q. In __________ operation, the cutting force is maximum when the tooth begins its cut and reduces it to minimum when the tooth leaves the work.

View solution

Q. The taper on the lathe spindle is

View solution

Q. In machining cast iron, no cutting fluid is required.

View solution

Q. In machining metals, surface roughness is due to

View solution

Q. A diamond locating pin is used in jigs and fixtures because

View solution