Q. A beam supported at its both ends is not a simply supported beam.

View solution

Q. The stress at which the extension of the material takes place more quickly as compared to the increase in load, is called

View solution

Q. A steel bar of 5 mm is heated from 15° C to 40° C and it is free to expand. The bar Will induce

View solution

Q. A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum normal stress will be

View solution

Q. Two shafts 'A' and 'B' transmit the same power. The speed of shaft 'A' is 250 r.p.m. and that of shaft 'B' is 300 r.p.m. The shaft 'B' has the greater diameter.

View solution

Q. The stress induced in a body, when suddenly loaded, is __________ the stress induced when the same load is applied gradually.

View solution

Q. The point of contraflexure is a point where

View solution

Q. The simply supported beam 'A' of length l carries a central point load W. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is W. The ratio of maximum deflections between beams A and B is

View solution

Q. The maximum stress produced in a bar of tapering section is at

View solution

Q. The energy stored in a body when strained within elastic limit is known as

View solution

Q. In compression test, the fracture in cast iron specimen would occur along

View solution

Q. In the torsion equation the term J/R is called

View solution

Q. Strain resetters are used to

View solution

Q. The torque transmitted by a solid shaft of diameter (D) is (where τ = Maximum allowable shear stress)

View solution

Q. When a rectangular beam is loaded transversely, the maximum compressive stress is developed on the

View solution

Q. The bending stress in a beam is __________ section modulus.

View solution

Q. When shear force at a point is zero, then bending moment is __________ at that point.

View solution

Q. When a bar is cooled to - 5°C, it will develop

View solution

Q. The limit of eccentricity is based upon no tension condition.

View solution

Q. The strain energy stored in a solid circular shaft subjected to shear stress (τ) is (where C = Modulus of rigidity for the shaft material)

View solution