Q. The bending moment diagram for a simply supported beam carrying a uniformly distributed load of w per unit length, will be

View solution

Q. The bending moment at the centre of a simply supported beam with a gradually varying load from zero at both ends to w per metre at the centre is wl/4.

View solution

Q. A body is subjected to a direct tensile stress of 300 MPa in one plane accompanied by a simple shear stress of 200 MPa. The maximum shear stress will be

View solution

Q. In a thick cylindrical shell subjected to an internal pressure (p), the tangential stress is always a tensile stress where as the radial stress is a compressive stress

View solution

Q. A column is said to be a short column, when

View solution

Q. In a thick cylindrical shell subjected to an internal pressure (p), the radial stress across the thickness of the cylinder is

View solution

Q. In order to avoid tearing off the plate at an edge, the distance from the centre of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)

View solution

Q. In a riveted joint, when the rivets in the various rows are opposite to each other, the joint is said to be

View solution

Q. The load required to produce a unit deflection in a spring is called

View solution

Q. A pressure vessel is said to be a thin shell when it is made of thin sheets.

View solution

Q. When a column is subjected to an eccentric load, the stress induced in the column will be

View solution

Q. Which of the following statement is wrong?

View solution

Q. When a shaft is subjected to a twisting moment, every cross-section of the shaft will be under

View solution

Q. A double strap butt joint with equal straps is

View solution

Q. At the neutral axis of a beam

View solution

Q. The line of intersection of the neutral layer with any normal cross-section of the beam is called neutral axis.

View solution

Q. In a thick cylindrical shell subjected to an internal pressure (p), the maximum radial stress at the inner surface of the shell is

View solution

Q. Shear strength of the welded joint for double parallel fillet is (where τ = Allowable shear stress for weld metal)

View solution

Q. The strength of the un-riveted or solid plate per pitch length is

View solution

Q. A simply supported beam is one which is supported on more than two supports.

View solution