Question

The ratio of the __________ to the volume at cut-off is called expansion ratio.

a.

swept volume

b.

clearance volume

c.

Can't say

d.

None of these

Posted under Mechanical Engineering

Answer: (a).swept volume

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The ratio of the __________ to the volume at cut-off is called expansion ratio.

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In water tube boilers, the water passes through the tubes which are surrounded by flames and hot gases.

Q. Which of the following is a water tube boiler ?

Q. The number of fire tubes in a Cochran boiler are

Q. The actual power supplied by the engine crankshaft is called

Q. The draught produced by a steam jet issuing from a nozzle placed in the chimney is called

Q. The chimney draught varies with

Q. Benson boiler requires

Q. The high pressure and low pressure cylinders in a Tandem type compound engine are regarded as having cranks

Q. The amount of water evaporated or steam produced in kg per kg of fuel burnt is known as power of a boiler.

Q. The fire tubes in a Cochran boiler usually have __________ diameter.

Q. Cut-off governing as compared to throttle governing is

Q. A compound steam engine in which piston rods of high pressure and low pressure cylinders ' are attached to two different cranks set at 180° to each other, is called

Q. The heat balance sheet for the boiler shows the

Q. The performance of a boiler is measured by the

Q. The evaporative capacity of a boiler is defined as the evaporation of 15.653 kg of water per hour from and at 100° C.

Q. The maximum heat loss is a boiler occurs due to

Q. For maximum discharge through a chimney, the temperature of flue gases inside the chimney should the slightly more than the atmospheric temperature.

Q. The internal flue tubes of a Lancashire boiler are reduced in diameter at the back to provide access to the lower part of the boiler.

Q. A device in which some portion of waste heat of flue gases is recovered to heat the air before it passes to the furnace for combustion purpose, is knwon as

Q. In a fire tube boiler, the water is contained inside the tubes which are surrounded by flames and hot gases from outside.

Recommended Subjects

Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!