Q. According to Indian standard specifications, a plain carbon steel designated by 40C8 contains carbon

View solution

Q. The machine screws are

View solution

Q. A bolt is designed on the basis of __________ with a large factor of safety.

View solution

Q. When a circular beam of diameter d is subjected to a shear force F, the maximum shear stress induced will be

View solution

Q. In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant, then it will be necessary to

View solution

Q. Which of the following statement is wrong ?

View solution

Q. The draw of cotter should not be more than

View solution

Q. The bolts of smaller diameter than M16 are not permitted in making fluid tight joints.

View solution

Q. In a marine flange coupling, the pitch circle diameter of bolts is taken as

View solution

Q. The steel widely used for motor car crankshafts is

View solution

Q. When compared to the rod of the same diameter and material, a wire rope

View solution

Q. According to Indian standards, total number of fundamental deviations are

View solution

Q. In the calculation of induced shear stress in helical springs, the Wahl's stress factor is used to take care of

View solution

Q. Creep in belt is due to

View solution

Q. The minimum number of teeth on the pinion which will mesh with any gear without interference for 20° full depth involute teeth will be

View solution

Q. A bolt of M 24 x 2 means that

View solution

Q. In designing a sleeve coupling, outer diameter of the sleeve is taken as (where d = Diameter of the shaft)

View solution

Q. In order to ensure self locking in a screw jack, it is essential that helix angle is __________ friction angle.

View solution

Q. In case of thick cylinders, the tangential stress across the thickness of cylinder is

View solution

Q. The cam follower generally used in automobile engines is

View solution