Question

According to I.B.R., the efficiency of a double riveted butt joint with double cover straps of equal width should be

a.

45 to 60%

b.

63 to 70%

c.

70 to 83%

d.

80 to 90%

Posted under Mechanical Engineering

Answer: (c).70 to 83%

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. According to I.B.R., the efficiency of a double riveted butt joint with double cover straps of equal width should be

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The buckling load will be maximum for a column, if

Q. The cap screws are

Q. In skew bevel gearing, the axes of shafts are

Q. A chain drive transmits __________ power as compared to belt drive.

Q. The stress in the bar when the load is applied suddenly is __________ as compared to the stress induced due to gradually applied loads.

Q. A triple riveted butt joint with double straps of unequal width is to be designed for a boiler shell. The pitch of the rivets in the outer row is double the pitch in the inner row and zig-zag riveting is proposed. Which of the following statement is correct?

Q. The form factor of a helical gear __________ with the increase in the helix angle.

Q. The taper on a rectangular sunk key is

Q. When carbon in the cast iron is in the form of cementite, the cast iron will be of white colour.

Q. A type of brake commonly used in motor cars is a

Q. In a nut and bolt, the diameter at which the ridges on the bolt are in complete touch with the ridges of the corresponding nut, is called pitch diameter.

Q. A double strap butt joint (with equal straps) is

Q. For a bevel gear having the pitch angle θ , the ratio of formative number of teeth (TE) to actual number of teeth (T) is

Q. The modulus of elasticity for mild steel is approximately equal to

Q. A connecting rod subjected to an axial load may buckle with

Q. When the lubricant is forced between the journal and the bearing by external pressure, the bearing is called hydrostatic lubricated bearing.

Q. Crushing resistance required to crush the rivet per pitch length is

Q. Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole, and σt = Permissible tensile stress for plate material)

Q. The buttress threads have low frictional resistance characteristic of the square threads and have the same strength of V-threads.

Q. The tension on the slack side of the belt is __________ the tension on the tight side of the belt.

Recommended Subjects

Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!