Question
a.
secant of its reduced bearing
b.
sine of its reduced bearing
c.
cosine of its reduced bearing
d.
tangent of its reduced bearing.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The length of a traverse leg may be obtained by multiplying the latitude and
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Pick up the correct statement from the following :
View solution
Q. An internal focussing type surveying telescope, may be focussed by the movement of
View solution
Q. An imaginary line lying throughout on the surface of the earth and preserving a constant inclination to the horizontal, is called
View solution
Q. An angles of 45° with a chain line may be set out with
View solution
Q. Pick up the correct statement from the following :
View solution
Q. The imaginary line passing through the intersection of cross hairs and the optical centre of the objective, is known as
View solution
Q. A dumpy level was set up at mid-point between pegs A and B, 80 m apart and the staff readings were 1.32 and 1.56. When the level was set up at a point 10 m from A on BA produced, the staff readings obtained at A and B were 1.11 and 1.39. The correct staff reading from this set up at S should be
View solution
Q. The staff intercept will be
View solution
Q. Horizontal distances obtained tacheometerically are corrected for
View solution
Q. If the long chord and tangent length of a circular curve of radius R are equal the angle of deflection, is
View solution
Q. Pick up the correct statement from the following :
View solution
Q. In setting up a plane table at any station
View solution
Q. The angle of intersection of a contour and a ridge line, is
View solution
Q. The area of any irregular figure of the plotted map is measured with
View solution
Q. Probable accidental error in precise levelling as recommended by International Geodetic Association, should not exceed (where k is in kilometers.)
View solution
Q. The curvature of the earth's surface, is taken into account only if the extent of survey is more than
View solution
Q. In chain surveying, perpendiculars to the chain line, are set out by
View solution
Q. The difference in the lengths of an arc and its subtended chord on the earth surface for a distance of 18.2 km, is only
View solution
Q. The boundary of water of a still lake, represents
View solution
Q. Diaphragm of a surveying telescope is held inside
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!