Q. The area of any irregular figure of the plotted map is measured with

View solution

Q. Probable accidental error in precise levelling as recommended by International Geodetic Association, should not exceed (where k is in kilometers.)

View solution

Q. The curvature of the earth's surface, is taken into account only if the extent of survey is more than

View solution

Q. In chain surveying, perpendiculars to the chain line, are set out by

View solution

Q. The difference in the lengths of an arc and its subtended chord on the earth surface for a distance of 18.2 km, is only

View solution

Q. The boundary of water of a still lake, represents

View solution

Q. Diaphragm of a surveying telescope is held inside

View solution

Q. In a precision traverse, included angles are measured by setting the vernier

View solution

Q. Pick up the correct statement from the following :

View solution

Q. If the length of a transition curve to be introduced between a straight and a circular curve of radius 500 m is 90 m, the maximum perpendicular offset for the transition curve, is

View solution

Q. The magnetic bearing of a line is 32° and the magnetic declination is 10° 15' W. The true bearing is

View solution

Q. If deflection angles are measured in a closed traverse, the difference between the sum of the right-hand and that of the left hand angles should be equal to

View solution

Q. Locating the position of a plane table station with reference to three known points, is known as

View solution

Q. If D is the degree of the curve of radius R, the exact length of its specified chord, is

View solution

Q. If the chain line which runs along N-S direction is horizontal and the ground in E-W direction is sloping

View solution

Q. A lens or combination of lenses in which the following defect is completely eliminated is called aplanatic

View solution

Q. While setting a plane table at a station it was found that the error in centering was 30 cm away from the ray of length 40 m drawn from the station. If the scale of the plan is 1 cm = 2 cm, the displacement of the end of the ray in plan from the true position will be

View solution

Q. In precision theodolite traverse if included angles are read twice and the mean reading accepted using both verniers having a least count of 30". Assuming the instrument to be in perfect adjustment, linear measurements correct to 6 mm per 30 metre tape duly corrected for temperature, slope and sag, the angular error of closure not to exceed (where n is the number of traverse legs)

View solution

Q. Straight, parallel and widely spaced contours represent

View solution

Q. The theodolites used for making tacheometric observations by optical wedge system, are

View solution