Q. Determination of water content of a soil sample suspected to contain gypsum is made by drying the sample for longer period at a temperature not more than

View solution

Q. Water formed transported soil is

View solution

Q. A decrease in water content results in a reduction of the volume of a soil in

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Number of piles required to support a column, is

View solution

Q. The soil moisture driven off by heat, is called

View solution

Q. If the specific gravity of a soil particle of 0.05 cm diameter is 2.67, its terminal velocity while settling in distilled water of viscosity, 0.01 poise, is

View solution

Q. The direct shear test suffers from the following disadvantage:

View solution

Q. For a clay slope of height of 10 m, the stability number is 0.05, γ = 2.0 t/m³, C = 2.5 t/m², the critical height of the slope of the soil, is

View solution

Q. If σ0' and σ' represent initial and increased pressure ; e0 and e void ratios corresponding to initial and increased pressure ; and C0 the compression index (dimensionless), then, the virgin compression curve as expressed by Terzaghi empirical formula is

View solution

Q. The equation τ = C + σ tan φ is given by

View solution

Q. You are given a sample of soil containing coarse grains to determine its water content, you will use

View solution

Q. Pick up the incorrect statement from the following:

View solution

Q. The maximum load carried by a pile, when it continues to sink without further increase of load, is known as

View solution

Q. The soil which contains finest grain particles, is

View solution

Q. The angle between the directions of the failure and the major principal plane, is equal to

View solution

Q. The compressibility of clays, is caused due to:

View solution

Q. A phreatic line is defined as the line within a dam section below which there are

View solution

Q. The ratio of the difference between the void ratio of the soil in its loosest state and its natural void ratio (e) to the difference between the void ratios in the loosest and fully dense state, is generally termed as

View solution

Q. Pick up the correct statement from the following:

View solution