Question
a.
hydraulic gradient
b.
piezometric line
c.
pressure grade line
d.
all the above.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The line joining the points to which the liquid rises in vertical piezometer tubes fitted at different cross-sections of a conduit, is known as
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Practical fluids possess
View solution
Q. The depth of the centre of pressure on a vertical rectangular gate (4 m wide, 3 m high) with water upto top surface, is
View solution
Q. The differential equation dp/ρ + gdz + vdv = 0 for a fluid motion is suggested by
View solution
Q. An open container filled with water is moved vertically downward with a uniform linear acceleration. The pressure at its bottom will be
View solution
Q. For uniform flow in canals
View solution
Q. If H is height of the liquid above the sill, the effect of end contractions, according to Francis formula, is
View solution
Q. Pick up the correct statement from the following :
View solution
Q. The pressure less than atmospheric , pressure, is known
View solution
Q. A rise or fall of liquid in a glass tube of a very small diameter when dipped is
View solution
Q. To measure very low pressure, we use
View solution
Q. If v1 and v2 are the velocities of flow before and after sudden enlargement in a pipe, the head loss given by Carnot and Borda equation, is
View solution
Q. Equation of continuity of fluids is applicable only if
View solution
Q. The flow in open channel is said to be critical if the Froude number is :
View solution
Q. An orifice is an opening in a vessel with
View solution
Q. The imaginary line drawn such that the tangents at its all points indicate the direction of the velocity of the fluid particles at each point, is called
View solution
Q. To avoid the tendency of separation of liquid flow, the most suitable ratio of the diameters of the throat and the pipe, is
View solution
Q. The instrument used for measuring the velocity of flow, is known as
View solution
Q. For a long pipe, the head loss
View solution
Q. On a flow net diagram, the distance between two consecutive steam lines at two successive sections are 1 cm and 0.5 cm respectively. If the velocity at the first section is 1 m/sec, the velocity at the second is
View solution
Q. The flow is called rotational if its velocity normal to the plane of area is equal to
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
