Q. For all practical purposes, the modulus of elasticity of steel is assumed

View solution

Q. The grade of reinforced concrete to be used in sea water or structures exposed to sea water should be

View solution

Q. If the specified thickness of a footing is 100 cm, the depth of the form work may be tolerated from

View solution

Q. If the main reinforcement of the slab is parallel to a T-beam, the transverse reinforcement at mid span of the slab is provided at least ......of main reinforcement

View solution

Q. For spans upto 10 m, the safe span to depth ratio for

View solution

Q. The angle of inclination of the lacing bars with axis of the member is kept between

View solution

Q. The distance of the critical section for shear from the periphery of the column or drop panal is at a distance (where d is effective depth of flat slab).

View solution

Q. If fck is characteristic compressive strength of concrete, the flexural and split tensile strength fcr = a√fck N/mm² where the value of a is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The value of the constant K in the formula As = K.bd/fs for determining the minimum area of tension reinforcement in a beam is

View solution

Q. The concrete may be accepted if the average equivalent cube strength of the cores, is at least 85% of the cube strength of the concrete grade at the specified age and no individual core possesses strength less than

View solution

Q. The slenderness ratio of a tie in a roof truss if subjected to action of wind and seismic forces, should not be greater than

View solution

Q. For concreting of shallow sections with vibration, the work ability of concrete should be

View solution

Q. The slenderness effect of a wall is considered if the effective height of the wall exceeds the thickness

View solution

Q. For achieving suitably a low permeability

View solution

Q. Minimum thickness of steel work directly exposed to weather and accessible for cleaning and repainting, the thickness should be not less than

View solution

Q. In limit state method, the design bond stress of M 30 grade concrete for plain bars in tension, is

View solution

Q. If the end of a beam of span L carrying a designed load W is partially restrained by a built up wall, it is designed to resist the negative moment at the face of the support, equal to

View solution

Q. Generally acceptable nominal size of aggregates for reinforced concrete, is

View solution

Q. Moist sand may contain surface water by mass upto

View solution