Q. Pick up the correct statement from the following:

View solution

Q. The value of the constant K in the formula As = K.bd/fs for determining the minimum area of tension reinforcement in a beam is

View solution

Q. The concrete may be accepted if the average equivalent cube strength of the cores, is at least 85% of the cube strength of the concrete grade at the specified age and no individual core possesses strength less than

View solution

Q. The slenderness ratio of a tie in a roof truss if subjected to action of wind and seismic forces, should not be greater than

View solution

Q. For concreting of shallow sections with vibration, the work ability of concrete should be

View solution

Q. The slenderness effect of a wall is considered if the effective height of the wall exceeds the thickness

View solution

Q. For achieving suitably a low permeability

View solution

Q. Minimum thickness of steel work directly exposed to weather and accessible for cleaning and repainting, the thickness should be not less than

View solution

Q. In limit state method, the design bond stress of M 30 grade concrete for plain bars in tension, is

View solution

Q. If the end of a beam of span L carrying a designed load W is partially restrained by a built up wall, it is designed to resist the negative moment at the face of the support, equal to

View solution

Q. Generally acceptable nominal size of aggregates for reinforced concrete, is

View solution

Q. Moist sand may contain surface water by mass upto

View solution

Q. The minimum horizontal distance between two parallel main reinforcing bars, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The spans of filler joists supporting a slab may be considered approximately equal if the longest span does not exceed the shortest span more than

View solution

Q. Removal of props under

View solution

Q. To achieve uniform colour and consistency of the concrete by using ordinary Portland cement, the mixing time may be

View solution

Q. For the proportions

View solution

Q. Columns are designed for a minimum eccentricity equal to 1/30 (unsupported length ofthe column), subject to a minimum of

View solution