Q. For B.G. single track, the section of the tunnel must have a width

View solution

Q. Which one of the following statements is not correct for heading and benching method of tunnelling ?

View solution

Q. The difference of heights of the tunnels above rail tops of BG and MG tracks is kept

View solution

Q. In case of drift method of tunnelling, the drift may be excavated at

View solution

Q. A tunnel is found more advantageous as compared to the alternate routes because it:

View solution

Q. For B.G. single track railway, the height of the tunnel above top of rails should be

View solution

Q. Which one of the following methods is generally used for the layout of the muck-car tracks

View solution

Q. For transferring the tunnel alignment through shafts, we adopt the following steps :

1. Hanging two or more plumb lines in the shaft
2. Determining the bearing of the plumb lines i.e. plumb plane
3. Suspending a 35 kg weight by each plumb line
4. Immersing the weights of both the plumb lines in the buckets containing water.

The correct sequence of steps is :

View solution

Q. For initial surveys of tunnels, the following activities are involved:

1. Marking portal point with concrete pillars on the ground
2. Marking tunnel obligatory points on the topographical maps
3. Preliminary setting of the tunnel on the topographical Survey of India maps
4. Driving lines between the fixed obligatory points.

The correct sequence of the activities is :

View solution

Q. For full face method, the excavation to be done is generally divided into

View solution

Q. The tunnels, the artificial underground passages are constructed for :

View solution

Q. Which one of the following methods is generally adopted for tunnelling in firm ground

View solution

Q. An overhead track on a large truss frame is required in case of car changer by

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The length of the needle beam used in needle beam method of tunnelling is usually

View solution

Q. High pressure grouting is generally restored for concreting in the lining if the rock strata is:

View solution

Q. For hauling muck from the tunnel, the following type of muck-car is used :

View solution

Q. Which one of the following methods is adopted for permanent drainage of tunnels :

View solution

Q. Pick up the correct statement regarding drilling a tunnel from the following:

View solution

Q. For tunnels exceeding 300 m in length, the grade should be provided below

View solution