Question

In following figure, what will be R1 and R2 for maximum symmetrical swing if VCSat ≈ 0. Given that RE = 200 Ω, RC = 400 Ω, VCC = 20 V, β = 99

a.

6 k

b.

3 k, 6 k

c.

9.9 k, 2.4 k

d.

2.4 k, 9.9 k

Answer: (d).2.4 k, 9.9 k

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In following figure, what will be R1 and R2 for maximum symmetrical swing if VCSat ≈ 0. Given that RE = 200 Ω, RC = 400 Ω, VCC = 20 V, β = 99

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Assertion (A): The circuit in figure produces repetitive narrow pulses when input is fed with sine or triangular waveform having peak value more than + V

Reason (R): The high gain op-amp produces voltages at two levels. If input is more than + V, the output is + 15 V otherwise the output is - 15 V.

Q. For CE amplifier of figure, the slope of ac load line is

Q. A non-inverting op-amp summer is shown in figure, the output voltage V0 is

Q. In figure if C is replaced by short circuit then RB will be

Q. In the circuit figure LED will be on when v1 is

Q. Figure shows a portion of linear v - i characteristics of diode. If applied voltage is + 6 V, the current will be

Q. In figure the zener current

Q. In the circuit of figure the diode

Q. In the circuit of figure, v1 = v2 = 10 V. Then

Q. The inverting op-amp shown in the figure has an open loop gain to 100. The closed loop given Vo/Vs is

Q. Figure shows a self bias circuit for FET amplifier, ID = 4 mA. Then IS =

Q. In the CE equivalent circuit of figure, the voltage gain is

Q. In the circuit shown in figure, RC = 10k, RE = 150Ω, β = 100, I = 1 mA. The value of A = Vo/Vs, will be

Q. Which of the following is correct?

Q. In figure, ID = 4 mA. Then VD =

Q. A circuit using an op-amp is shown in the given figure. It has

Q. In figure VBE = 0.7 V. The base current is

Q. The circuit in the given figure is

Q. A bridge diode circuit using ideal diodes has in input voltage of 20 sin ωt volts. The average and rms values of output voltage are

Q. In the circuit of figure v1 = 8 V and v2 = 0. Which diode will conduct (Assume ideal diodes)?

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!