Question

Circuit shown in the figure is

a.

astable multivibrator

b.

monostable multivibrator

c.

VCO

d.

ramp Generator

Answer: (a).astable multivibrator

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Circuit shown in the figure is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The period of oscillation of a symmetrical multivibrator depends upon the discharging time constant and is roughly given by

Q. Symbol shown in figure represents a

Q. In figure it is desired that output wave is symmetrical. Then

Q. The circuit shown in figure will act as

Q. The given circuit has a feedback factor of

Q. The ripple factor of a power supply is given by

Q. In the op-amp circuit shown in figure the current through load resistance RL is

Q. RC network shown in the given figure can provide a maximum theoretical phase shift of

Q. Assertion (A): In the circuit shown figure the diode is used to protect the active devices. Transistor T goes into saturation when a positive pulse is applied at base and non conducting

Reason (R): When the current in an inductor is suddenly stopped, a high voltage is induced across it.

Q. Following figure is a signal conditioning Amplifier, changes gain depending upon the polarity of Vs. What will be circuit voltage gain for + Vs and for - Vs if D2 is ideal.

Q. The circuit of the figure is an example of feedback of the following type

Q. Oscillation frequency in Wein bridge oscillator is

Q. In figure VCC = + 30 V, IC corresponding to Q point is 1 mA. If RC = 5 kΩ and RE = 5 kΩ, VCE corresponding to Q point is

Q. Symbol shown in figure represents a

Q. In the op-amp circuit of figure, V0 =

Q. The re model equivalent circuit shown in figure is for

Q. For the circuit of figure the input and output Miller resistances are

Q. In the circuit of figure for sinusoidal input the waveform of the output will be as shown in

Q. In the case of an amplifier, the normalised voltage gain is given by following equation.
where f0 is zero frequency, fP is pole frequency. For a standard frequency response of the amplifier,

Q. Figure shows a

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!