Q. For the circuit of figure the input and output Miller resistances are

View solution

Q. In the circuit of figure for sinusoidal input the waveform of the output will be as shown in

View solution

Q. In the case of an amplifier, the normalised voltage gain is given by following equation.
where f0 is zero frequency, fP is pole frequency. For a standard frequency response of the amplifier,

View solution

Q. Figure shows a

View solution

Q. In a CC circuit the current gain is

View solution

Q. For the circuit shown in figure low cut-off frequency is

View solution

Q. In the amplifier circuit figure the quiescent point voltage and current are

View solution

Q. For a BJT, β and a are related as

View solution

Q. The circuit diagram shown in the figure consists of transistors in

View solution

Q. The circuit of figure is called

View solution

Q. In the equivalent circuit of figure voltage gain is

View solution

Q. Figure represents a

View solution

Q. In a closed loop non-inverting amplifier, constructed using single break-frequency op-amp, bandwidth with feedback can be written as. (f0 - break frequency, β - gain of the feedback circuit, A - open loop voltage gain, Af - closed loop voltage gain)

View solution

Q. Two identical FETs, each characterised by the parameters gm and rd are connected in parallel. The composite FET is then characterised by the parameters

View solution

Q. DC voltage of the order of a few mV can be accurately of measured by

View solution

Q. In a CE amplifier the input impedance is equal to the ratio of

View solution

Q. For a system to work, as oscillator the total phase shift of the loop gain must be equal to

View solution

Q. An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a

View solution

Q. To prevent a DC return between source and load, it is necessary to use

View solution

Q. For a base current of 10 μA, what is the value of collector current in common emitter if βdc = 100

View solution