Question
where f0 is zero frequency, fP is pole frequency. For a standard frequency response of the amplifier,
a.
fP >> f0
b.
fP = f0
c.
fP << f0
d.
f0 = 2 fP
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In the case of an amplifier, the normalised voltage gain is given by following equation. where f0 is zero frequency, fP is pole frequency. For a standard frequency response of the...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Figure shows a
View solution
Q. In a CC circuit the current gain is
View solution
Q. For the circuit shown in figure low cut-off frequency is
View solution
Q. In the amplifier circuit figure the quiescent point voltage and current are
View solution
Q. For a BJT, β and a are related as
View solution
Q. The circuit diagram shown in the figure consists of transistors in
View solution
Q. The circuit of figure is called
View solution
Q. In the equivalent circuit of figure voltage gain is
View solution
Q. Figure represents a
View solution
Q. In a closed loop non-inverting amplifier, constructed using single break-frequency op-amp, bandwidth with feedback can be written as. (f0 - break frequency, β - gain of the feedback circuit, A - open loop voltage gain, Af - closed loop voltage gain)
View solution
Q. Two identical FETs, each characterised by the parameters gm and rd are connected in parallel. The composite FET is then characterised by the parameters
View solution
Q. DC voltage of the order of a few mV can be accurately of measured by
View solution
Q. In a CE amplifier the input impedance is equal to the ratio of
View solution
Q. For a system to work, as oscillator the total phase shift of the loop gain must be equal to
View solution
Q. An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a
View solution
Q. To prevent a DC return between source and load, it is necessary to use
View solution
Q. For a base current of 10 μA, what is the value of collector current in common emitter if βdc = 100
View solution
Q. Which of the following oscillators is suitable for frequencies in the range of mega hertz?
View solution
Q. Consider the following statements : A clamper circuit
1. adds or subtracts a dc voltage to a waveform
2. does not change the waveform
3. amplifiers the waveform
Which are correct?
View solution
Q. A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
