Q. In an amplifier with a gain of - 1000 and feedback factor β = - 0.1, the change in gain is 20% due to temperature. The change in gain for feedback amplifier will be

View solution

Q. The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be

View solution

Q. In a class C power amplifier the input signal has a frequency of 250 kHz. If the collector current pulses are 0.1 μs wide, the duty cycle of current waveform is

View solution

Q. The dissipation at the collector is in the quiescent state and increases with excitation in the case of a

View solution

Q. The open loop gain of an ideal op-amp is

View solution

Q. The ideal characteristics of a stabilizer is

View solution

Q. A difference amplifier using op-amp has closed loop gain = 50. If input is 2 V to each of inverting and non-inverting terminals, output is 5 mA. Then CMRR =

View solution

Q. The coupling capacitor in amplifier circuits

View solution

Q. An ideal op-amp has zero slew rate.

View solution

Q. In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is

View solution

Q. In a half wave diode rectifier circuit the current flows in the load circuit for

View solution

Q. In a push pull circuit

View solution

Q. A transistor with a = 0.9 and ICBO = 10 μA is biased so that IBQ = 90 μA. Then IEQ will be

View solution

Q. The ripple factor of a half wave rectifier is more than 2.

View solution

Q. In a CE amplifier drives a low load resistance directly the result will be

View solution

Q. For high frequencies a capacitor like

View solution

Q. In an amplifier the voltage gain is the ratio of

View solution

Q. A typical value of gm for a FET is about 25 μs.

View solution

Q. A transistor has two p-n junctions. The batteries should be connected such that

View solution

Q. The value of parameter re used in re transistor model

View solution