Q. The value of parameter re used in re transistor model

View solution

Q. Assertion (A): In a full wave rectifier output the lowest ac component is at twice the input frequency

Reason (R): In a full wave rectifier, the output waveform consists of half sinusoids

View solution

Q. An op-amp has zero gain for common mode inputs. Then CMRR =

View solution

Q. Assertion (A): Negative feedback reduces the bandwidth of an amplifier

Reason (R): Negative feedback stabilizes the gain of an amplifier

View solution

Q. A 12 kHz pulse wave-form is amplified by a circuit having an Upper cut-off frequency of 1 MHz. The minimum input pulse width that can be accurately reproduced is

View solution

Q. Feedback factor may be less or more than 1.

View solution

Q. An RC oscillator uses

View solution

Q. The main advantage of CMOS circuit is

View solution

Q. Ac signals are given to both inverting and non-inverting terminals of an op-amp. When will the output maximum

View solution

Q. The input voltage for starting oscillations in an oscillator is caused by

View solution

Q. The current flowing in a certain P-N junction at room temperature is 2 x 10¯⁷ Amp. When a large reverse biased voltage is applied. Calculate the current flowing when 0.1 volts is applied.

View solution

Q. In a CE amplifier

View solution

Q. The voltage gain of an amplifier without and with feedback are 100 and 20. The negative feedback is

View solution

Q. Calculate the conductivity of pure silicon at room temperature when the concentration of carriers is 1.6 x 10¹ᴼ per cm³. Take μe = 1500 cm²/V-sec, μh = 500 cm²/V-sec at room temperature,

View solution

Q. A potential of 7 V is applied to a silicon diode. A resistance of 1 kΩ is also connected in series. If the diode is forward biased, the current in the circuit is

View solution

Q. In a voltage regulated power supply the zener operates in the breakdown region when (Vin is input voltage and Vz is zener breakdown voltage)

View solution

Q. The parameter h11 for CB circuit is higher than that for CE circuit.

View solution

Q. Assertion (A): In CE amplifier the emitter is at ground potential for ac signals

Reason (R): A CE amplifier has near unity voltage gain

View solution

Q. An oscillator requires an amplifier

View solution

Q. A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is

View solution