Question

The voltage gain of an amplifier without and with feedback are 100 and 20. The negative feedback is

a.

4%

b.

5%

c.

20%

d.

80%

Answer: (a).4%

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The voltage gain of an amplifier without and with feedback are 100 and 20. The negative feedback is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Calculate the conductivity of pure silicon at room temperature when the concentration of carriers is 1.6 x 10¹ᴼ per cm³. Take μe = 1500 cm²/V-sec, μh = 500 cm²/V-sec at room temperature,

Q. A potential of 7 V is applied to a silicon diode. A resistance of 1 kΩ is also connected in series. If the diode is forward biased, the current in the circuit is

Q. In a voltage regulated power supply the zener operates in the breakdown region when (Vin is input voltage and Vz is zener breakdown voltage)

Q. The parameter h11 for CB circuit is higher than that for CE circuit.

Q. Assertion (A): In CE amplifier the emitter is at ground potential for ac signals

Reason (R): A CE amplifier has near unity voltage gain

Q. An oscillator requires an amplifier

Q. A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is

Q. The disadvantage of direct coupled amplifiers is

Q. A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is

Q. An ideal power supply has

Q. In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will

Q. A P-channel MOSFET operating in the enhancement mode is characterized by Vt = - 4 V and IDQ = - 10 mA, when VGSQ = - 5.5 V, what will be VGSQ if IDQ = -15 mA and ID, on = - 16 mA

Q. In a transistor E mode the collector current with the transistor in cut off region is

Q. Two CE stages, 1 and 2 are coupled through a capacitor. VCC is the same for both. Base resistances RB1 and RB2 are such that RB1 > RB2. Then

Q. In a two stage CE amplifier circuit, the ac collector resistance of the first stage depends on

Q. In a CE amplifier the ac cut off voltage is 9 V and slope of ac load line is - 0.5 mA/V. The ac saturation current is

Q. A differential amplifier consists of two CB amplifiers.

Q. A power transistor dissipates 5 W. If ambient temperature is 30° and case to air thermal resistance is 10° C/W, the case temperature is

Q. An R-C coupled amplifier has mid-frequency gain of 200 and a frequency response from 100 Hz to 20 kHz. A negative feedback network with β = 0.2 is incorporated into the amplifier circuit, the Bandwidth will be

Q. A full wave rectifier circuit using centre tapped transformer and a bridge rectifier are fed at 100 V, 50 Hz. The frequencies of outputs in these two rectifiers are

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!