Q. The main advantage of CMOS circuit is

View solution

Q. Ac signals are given to both inverting and non-inverting terminals of an op-amp. When will the output maximum

View solution

Q. The input voltage for starting oscillations in an oscillator is caused by

View solution

Q. The current flowing in a certain P-N junction at room temperature is 2 x 10¯⁷ Amp. When a large reverse biased voltage is applied. Calculate the current flowing when 0.1 volts is applied.

View solution

Q. In a CE amplifier

View solution

Q. The voltage gain of an amplifier without and with feedback are 100 and 20. The negative feedback is

View solution

Q. Calculate the conductivity of pure silicon at room temperature when the concentration of carriers is 1.6 x 10¹ᴼ per cm³. Take μe = 1500 cm²/V-sec, μh = 500 cm²/V-sec at room temperature,

View solution

Q. A potential of 7 V is applied to a silicon diode. A resistance of 1 kΩ is also connected in series. If the diode is forward biased, the current in the circuit is

View solution

Q. In a voltage regulated power supply the zener operates in the breakdown region when (Vin is input voltage and Vz is zener breakdown voltage)

View solution

Q. The parameter h11 for CB circuit is higher than that for CE circuit.

View solution

Q. Assertion (A): In CE amplifier the emitter is at ground potential for ac signals

Reason (R): A CE amplifier has near unity voltage gain

View solution

Q. An oscillator requires an amplifier

View solution

Q. A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is

View solution

Q. The disadvantage of direct coupled amplifiers is

View solution

Q. A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is

View solution

Q. An ideal power supply has

View solution

Q. In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will

View solution

Q. A P-channel MOSFET operating in the enhancement mode is characterized by Vt = - 4 V and IDQ = - 10 mA, when VGSQ = - 5.5 V, what will be VGSQ if IDQ = -15 mA and ID, on = - 16 mA

View solution

Q. In a transistor E mode the collector current with the transistor in cut off region is

View solution

Q. Two CE stages, 1 and 2 are coupled through a capacitor. VCC is the same for both. Base resistances RB1 and RB2 are such that RB1 > RB2. Then

View solution