Q. In a half wave diode rectifier circuit the current flows in the load circuit for

View solution

Q. In a push pull circuit

View solution

Q. A transistor with a = 0.9 and ICBO = 10 μA is biased so that IBQ = 90 μA. Then IEQ will be

View solution

Q. The ripple factor of a half wave rectifier is more than 2.

View solution

Q. In a CE amplifier drives a low load resistance directly the result will be

View solution

Q. For high frequencies a capacitor like

View solution

Q. In an amplifier the voltage gain is the ratio of

View solution

Q. A typical value of gm for a FET is about 25 μs.

View solution

Q. A transistor has two p-n junctions. The batteries should be connected such that

View solution

Q. The value of parameter re used in re transistor model

View solution

Q. Assertion (A): In a full wave rectifier output the lowest ac component is at twice the input frequency

Reason (R): In a full wave rectifier, the output waveform consists of half sinusoids

View solution

Q. An op-amp has zero gain for common mode inputs. Then CMRR =

View solution

Q. Assertion (A): Negative feedback reduces the bandwidth of an amplifier

Reason (R): Negative feedback stabilizes the gain of an amplifier

View solution

Q. A 12 kHz pulse wave-form is amplified by a circuit having an Upper cut-off frequency of 1 MHz. The minimum input pulse width that can be accurately reproduced is

View solution

Q. Feedback factor may be less or more than 1.

View solution

Q. An RC oscillator uses

View solution

Q. The main advantage of CMOS circuit is

View solution

Q. Ac signals are given to both inverting and non-inverting terminals of an op-amp. When will the output maximum

View solution

Q. The input voltage for starting oscillations in an oscillator is caused by

View solution

Q. The current flowing in a certain P-N junction at room temperature is 2 x 10¯⁷ Amp. When a large reverse biased voltage is applied. Calculate the current flowing when 0.1 volts is applied.

View solution