Question
a.
leakage current is minimized
b.
recombination will be increased in the base region
c.
the flow across the base regional is only because of electrons
d.
the flow across the base region is mainly because of holes
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a P-N-P junction transistor as compared to base region is more heavily doped so that
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In every practical oscillator the loop gain is slightly more than unit and amplitude of oscillations is limited by
View solution
Q. Which of the following is not valid in case of FETs?
View solution
Q. When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common base short circuit current gain a for the transistor is
View solution
Q. In a transistor which of the following region is very lightly doped and is very thin?
View solution
Q. The properties of FETs closely resemble those of a
View solution
Q. The purpose of providing groundings rings with MOSFET is to
View solution
Q. The minimum value of hfe of a transistor used in RC phase shift oscillator is
View solution
Q. Self bias is an example of __________ feedback that tends to stabilize the drain current against changes in temperature and JFET replacement.
View solution
Q. In a transistor amplifier, the reverse saturation current Iᴄᴑ
View solution
Q. When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common-emitter short-circuit current gain is
View solution
Q. Assertion (A): A common collector amplifier is used for matching a high impedance source to a low impedance load
Reason (R): A common collector amplifier has a near unity voltage gain
View solution
Q. In a crystal oscillator of the Colpitt's oscillator type, the crystal is put is place of the
View solution
Q. Class A and Class B power amplifiers predominate at
View solution
Q. In a class C operation VCC = 30 V and VCE(sat) = 2 V. The efficiency is
View solution
Q. In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is
View solution
Q. A voltage tripler circuit uses
View solution
Q. An op-amp uses
View solution
Q. In voltage amplifiers, the load resistance
View solution
Q. The RC network of wein bridge oscillator consists of resistors and capacitors of values R = 220 kΩ and C = 250 PF Determine the frequency of oscillation
View solution
Q. Which of the following statement is correct?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
