Q. In a transistor which of the following region is very lightly doped and is very thin?

View solution

Q. The properties of FETs closely resemble those of a

View solution

Q. The purpose of providing groundings rings with MOSFET is to

View solution

Q. The minimum value of hfe of a transistor used in RC phase shift oscillator is

View solution

Q. Self bias is an example of __________ feedback that tends to stabilize the drain current against changes in temperature and JFET replacement.

View solution

Q. In a transistor amplifier, the reverse saturation current Iᴄᴑ

View solution

Q. When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common-emitter short-circuit current gain is

View solution

Q. Assertion (A): A common collector amplifier is used for matching a high impedance source to a low impedance load

Reason (R): A common collector amplifier has a near unity voltage gain

View solution

Q. In a crystal oscillator of the Colpitt's oscillator type, the crystal is put is place of the

View solution

Q. Class A and Class B power amplifiers predominate at

View solution

Q. In a class C operation VCC = 30 V and VCE(sat) = 2 V. The efficiency is

View solution

Q. In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is

View solution

Q. A voltage tripler circuit uses

View solution

Q. An op-amp uses

View solution

Q. In voltage amplifiers, the load resistance

View solution

Q. The RC network of wein bridge oscillator consists of resistors and capacitors of values R = 220 kΩ and C = 250 PF Determine the frequency of oscillation

View solution

Q. Which of the following statement is correct?

View solution

Q. In a single stage differential amplifier, the output offset voltage is basically dependent on the mismatch of

View solution

Q. Which of the following amplifier circuits has highest input impedance?

View solution

Q. Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?

View solution