Question

In voltage amplifiers, the load resistance

a.

should be a small as possible

b.

should be as large as possible

c.

must be equal to output impedance

d.

must be half of output impedance

Answer: (b).should be as large as possible

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In voltage amplifiers, the load resistance

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The RC network of wein bridge oscillator consists of resistors and capacitors of values R = 220 kΩ and C = 250 PF Determine the frequency of oscillation

Q. Which of the following statement is correct?

Q. In a single stage differential amplifier, the output offset voltage is basically dependent on the mismatch of

Q. Which of the following amplifier circuits has highest input impedance?

Q. Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?

Q. A differentiating amplifier has capacitor in the input path.

Q. Which of the following statement about TRIAC is incorrect?

Q. A half wave diode rectifier and full wave diode bridge rectifier both have an input frequency of 50 Hz. The frequencies of outputs respectively are

Q. Overall efficiency of class B amplifier is

Q. For a transistor to have-a larger β it must have and a

Q. JFET is also known as

Q. Drain feedback bias is often used with

Q. CMRR of a difference amplifier is equal to

Q. The ac collector current is nearly equal to

Q. From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier

Q. In an amplifier, if the output current flows for 120° of the input cycle, the class of amplifier will be

Q. Assertion (A): If we overdrive an amplifier the output signal may get clipped

Reason (R): To dissipate heat to atmosphere a heat sink is sometimes attached to the case of transistor

Q. Which op-amp circuit uses a diode as one of the circuit components?

Q. Tuned amplifiers are used at radio frequencies.

Q. The knee voltages in silicon and germanium diodes respectively are

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!