Question

Assertion (A): A common collector amplifier is used for matching a high impedance source to a low impedance load

Reason (R): A common collector amplifier has a near unity voltage gain

a.

Both A and R are correct and R is correct explanation for A

b.

Both A and R are correct but R is not correct explanation for A

c.

A is correct R is wrong

d.

A is wrong R is correct

Answer: (b).Both A and R are correct but R is not correct explanation for A

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Assertion (A): A common collector amplifier is used for matching a high impedance source to a low impedance load Reason (R): A common collector amplifier has a near unity...

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In a crystal oscillator of the Colpitt's oscillator type, the crystal is put is place of the

Q. Class A and Class B power amplifiers predominate at

Q. In a class C operation VCC = 30 V and VCE(sat) = 2 V. The efficiency is

Q. In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is

Q. A voltage tripler circuit uses

Q. An op-amp uses

Q. In voltage amplifiers, the load resistance

Q. The RC network of wein bridge oscillator consists of resistors and capacitors of values R = 220 kΩ and C = 250 PF Determine the frequency of oscillation

Q. Which of the following statement is correct?

Q. In a single stage differential amplifier, the output offset voltage is basically dependent on the mismatch of

Q. Which of the following amplifier circuits has highest input impedance?

Q. Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?

Q. A differentiating amplifier has capacitor in the input path.

Q. Which of the following statement about TRIAC is incorrect?

Q. A half wave diode rectifier and full wave diode bridge rectifier both have an input frequency of 50 Hz. The frequencies of outputs respectively are

Q. Overall efficiency of class B amplifier is

Q. For a transistor to have-a larger β it must have and a

Q. JFET is also known as

Q. Drain feedback bias is often used with

Q. CMRR of a difference amplifier is equal to

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!