Q. If f is more than funity the gain of op-amp becomes less than 1.

View solution

Q. In a N-P-N transistor the function of the emitter is

View solution

Q. The properties of FETs resemble closely to

View solution

Q. The source of the harmonic distortion in a RC coupled transistor amplifier is usually

View solution

Q. Two transistors have same value of a but different gain (G) bandwidth (B) product. The transistors have similar geometry. However one of them is germanium and the other is silicon. The transistor with lower GB product

View solution

Q. Which distortion is least objectionable in case of audio amplifiers?

View solution

Q. In a single stage differential amplifier, the output offset voltage is mainly dependent on the mismatch of

View solution

Q. In a combination limiter with sinusoidal input voltage the output wave can be nearly square.

View solution

Q. Assertion (A): A Darlington amplifier has very low output impedance

Reason (R): The circuit has a low resistance RE between emitter and ground

View solution

Q. A Hartley oscillator uses

View solution

Q. A silicon PN junction diode under reverse bias has depletion region of width 10 μm. The relative permittivity of silicon, Ɛr = 11.7 and the permittivity of free space Ɛ₀ = 8.85 x 10¯¹² F/m. The depletion capacitance of the diode per square meter is

View solution

Q. A delay equalizer is a

View solution

Q. A cascade amplifier stage is equivalent to

View solution

Q. Which one of the following devices is not used as the controller in a stabilizer?

View solution

Q. The disadvantage of transformer coupling in amplifier is

View solution

Q. A transistor is said to be in a quiescent state when

View solution

Q. According to Barkhausen criteria in order to sustain the oscillations

View solution

Q. A Wien bridge oscillator uses

View solution

Q. In the above case, what will be the value of capacitor to obtain 100 kHz frequency?

View solution

Q. Equal amplitude ac signals are given as inputs to both inverting and given as inputs to both inverting and non-inverting terminals of an op-amp. The output will be zero when the phase difference between inputs is

View solution