Question
a.
low pass filter
b.
band pass filter
c.
all pass filter
d.
high pass filter
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A delay equalizer is a
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A cascade amplifier stage is equivalent to
View solution
Q. Which one of the following devices is not used as the controller in a stabilizer?
View solution
Q. The disadvantage of transformer coupling in amplifier is
View solution
Q. A transistor is said to be in a quiescent state when
View solution
Q. According to Barkhausen criteria in order to sustain the oscillations
View solution
Q. A Wien bridge oscillator uses
View solution
Q. In the above case, what will be the value of capacitor to obtain 100 kHz frequency?
View solution
Q. Equal amplitude ac signals are given as inputs to both inverting and given as inputs to both inverting and non-inverting terminals of an op-amp. The output will be zero when the phase difference between inputs is
View solution
Q. Which of the following can be used to isolate a low impedance from a high impedance source?
View solution
Q. A class C amplifier uses
View solution
Q. A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?
View solution
Q. The input to negative clamper has a peak value of Vp. Then in the output the positive and negative peaks are nearly
View solution
Q. In a common Emitter BJT amplifier, the maximum usable supply voltage is limited by
View solution
Q. High frequency oscillations can be caused by
View solution
Q. A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What will be the effect on output if the amplifier's gain is twice that required by the Barkhausen criterion?
View solution
Q. A transistor in CE mode is in saturation region. Then the collector is almost at
View solution
Q. The semi-conductor type 2 N 34 indicates
View solution
Q. The emitter bias largely depends on
View solution
Q. A limiter circuit can be built using a diode and resistance.
View solution
Q. In saturation region JFET acts like a
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
