Q. A transistor is said to be in a quiescent state when

View solution

Q. According to Barkhausen criteria in order to sustain the oscillations

View solution

Q. A Wien bridge oscillator uses

View solution

Q. In the above case, what will be the value of capacitor to obtain 100 kHz frequency?

View solution

Q. Equal amplitude ac signals are given as inputs to both inverting and given as inputs to both inverting and non-inverting terminals of an op-amp. The output will be zero when the phase difference between inputs is

View solution

Q. Which of the following can be used to isolate a low impedance from a high impedance source?

View solution

Q. A class C amplifier uses

View solution

Q. A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?

View solution

Q. The input to negative clamper has a peak value of Vp. Then in the output the positive and negative peaks are nearly

View solution

Q. In a common Emitter BJT amplifier, the maximum usable supply voltage is limited by

View solution

Q. High frequency oscillations can be caused by

View solution

Q. A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What will be the effect on output if the amplifier's gain is twice that required by the Barkhausen criterion?

View solution

Q. A transistor in CE mode is in saturation region. Then the collector is almost at

View solution

Q. The semi-conductor type 2 N 34 indicates

View solution

Q. The emitter bias largely depends on

View solution

Q. A limiter circuit can be built using a diode and resistance.

View solution

Q. In saturation region JFET acts like a

View solution

Q. FET can used in

View solution

Q. Each of two cascaded stages has a voltage gain of 30. The overall gain is

View solution

Q. A two stage amplifier has an upper cutoff frequency of 2 MHz and a lower cutoff frequency of 2 MHz and a lower cut off frequency of 30 Hz. If both stages are similar, their individual upper and lower cut off frequencies respectively are

View solution