Q. In an amplifier circuit the emitter is at ac ground potential in a

View solution

Q. An ideal op-amp has

View solution

Q. A class B amplifier

1. is biased just at cutoff
2. has a high theoretical efficiency of 78.5% because its quiescent current is low
3. is biased at midpoint of load line

Of the above statements

View solution

Q. In CE circuit the parameter f12 is very small.

View solution

Q. In which amplifier circuit is gate conductance negligible?

View solution

Q. Which of the following combinations has no phase inversion of the signal?

View solution

Q. Which of the following h parameters is an admittance?

View solution

Q. Assertion (A): Manufacturer's quote h parameters of transistor

Reason (R): h parameters of a transistor are easiest to measure

View solution

Q. The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to

View solution

Q. Wien bridge uses

View solution

Q. Which of the following is not necessarily the advantages of a push pull amplifier?

View solution

Q. Which of the following best represents the output impedance of an actual op-amp?

View solution

Q. The phase angle of lead circuit is

View solution

Q. A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The power gain is

View solution

Q. The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.

View solution

Q. In CE amplifier

View solution

Q. The phase angle of a lag circuit is

View solution

Q. CMOS is widely used in

View solution

Q. A JFET can operate on

View solution

Q. Which of the following is the point of reference JFET?

View solution