Question
a.
infinitely high
b.
around 1 kΩ
c.
around 50 Ω
d.
very small
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The input resistance of FET in the low frequency small signal operation is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Which of the following parameters of CE circuit has the unit of ohms?
View solution
Q. Whenever a JFET operates above pinch-off voltage
View solution
Q. A Weinbridge oscillator is a
View solution
Q. CMRR of an op-amp is about 0.1.
View solution
Q. A transistor amplifier has poles at
s1 = - 0.000245 x 10⁹ rad/sec.
s2 = - 0.0748 x 10⁹ rad/sec.
s3 = - 0.670 x 10⁹ rad/sec.
s4 = - 4.38 x 10⁹ rad/sec.
The upper 3 dB frequency of the amplifier will be
View solution
Q. An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What value of feedback will double the gain?
View solution
Q. The maximum theoretical efficiency for class A amplifier is
View solution
Q. Assertion (A): A class C amplifier can also be used as frequency multiplier
Reason (R): When narrow current pulses drive a resonant circuit the output can be a near perfect sine wave
View solution
Q. The parameter β of a BJT change by 300%. If self bias is used in the amplifier using this BJT, the quiescent value of IC and VCE remain almost the same.
View solution
Q. A bypass capacitor produces
View solution
Q. Rise time in a transistor is change from
View solution
Q. In a JFET, gates are always
View solution
Q. By connecting external resistances to a differential amplifier we can adjust
View solution
Q. A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What must be the minimum gain of the oscillator to provide oscillations?
View solution
Q. CMRR is the ratio of differential voltage gain to common mode gain.
View solution
Q. The purpose of impedance matching in an amplifier circuit is to achieve
View solution
Q. In a BJT CE amplifier circuit the value of coupling capacitor should be such that
View solution
Q. In order to rectify sinusoidal signals of millivolt range (< 0.6 V)
View solution
Q. The common gate amplifier has a characteristically __________ input resistance and a __________ output resistance.
View solution
Q. For input and later stages, BI-FET op-amp use
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
