Question

If k is dielectric constant of a medium, the velocity factor in that medium is

a.

A

b.

B

c.

C

d.

D

Answer: (b).B

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. If k is dielectric constant of a medium, the velocity factor in that medium is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Fourier series expansion of a real periodic signal with fundamental frequency is given by following equation. It is given that c₃ = 3 + j5. then c-₃ is

Q. A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t) where g(t) is given by below equation. The resulting signal is then passes through an ideal low pass filter with bandwidth 1 kHz the output of the low pass filter would be

Q. If a signal voltage Vs is accompanied by a noise voltage Vn the signal to noise ratio is

Q. A sequence x(n) with the z transform X(z) = z⁴ + z² - 2z + 2 - 3z - 4 is applied as an input to a linear, time invariant system with the impulse response h(n) = 2δ(n - 3) where δ(n) is given below. The output at n = 4 is

Q. In a satellite transponder the power amplifier feeds power P to the transmitting antenna of gain G. If distance of earth is d, the power flux density is

Q. In a two stage cascade amplifier the equivalent noise temperatures are Te1 and Te2. If the gains of the two stages are G1 and G2, the overall noise temperature Te is

Q. A π matching network for coupling the transmitter output of the antenna is shown in figure.
In this C₂ should be tuned for

Q. In figure (A) and (B)

Q. For a three stage cascaded amplifier, having gains of G₁, G₂ and G₃ and noise figures of F₁, F₂, F₃ the overall noise figure

Q. Which of the following could be the equation for non-linear resistor shown in figure?

Q. Figure shows the arrangement of

Q. Noise figure is defined as

Q. If N is the number of binary digits needed to assign individual binary code designations to the M quantization levels, the signal to quantization noise ratio S0/Nq in PCM is

Q. If Vs is signal voltage, Vn is noise voltage, signal to noise ratio S/N is defined as

Q. The PDF of a Gaussian random variable X is given by following equation. The probability of the event {X = 4} is

Q. A single tone modulating signal Vm cos ωt modulates a carrier A cos ωct. The carrier power (modulated) and side band powers are respectively

Q. Modulation index of a AM wave is measured using oscilloscope. The display on the CRO is as shown in figure it can be concluded that

Q. If f is frequency and d is distance, path attenuation a between isotropic antennas is given by

Q. If the transmitted pulse power of a radar is Pt (peak value) and the antenna is isotropic, the power density at a distance r is

Q. In delta modulation, the output signal to quantization noise ratio S0/Nq is (N is the number of bits)

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!