Q. In the given figure the circuits for input impedance of a microwave device with output ports match terminated. The device is

View solution

Q. The scattering matrix of magic tee is

View solution

Q. Guide wavelength (λg), cutoff wavelength (λc) and free space wavelength (λ₀) of a waveguide are related as

View solution

Q. Consider the following statements about directional coupler shown in the figure:

1. Ports 1 and 2 are decouple
2. Ports 3 and 4 are decoupled
3. Pots 1 and 3 are decoupled
4. Ports 1 and 4 are decoupled

Which of the above statements are correct?

View solution

Q. Two identical hybrid tees are joined as shown in the given figure. If 16 mW power is fed into port 1, the power output at ports 2 , 3, 1', 2', 3' respectively is

View solution

Q. If QL is loaded Q, QE is external Q and QU is unloaded Q of a microwave resonator, then

View solution

Q. Which of the following lines is non-radiating?

View solution

Q. Assertion (A): The impedance of a matched load is equal to characteristic impedance of line.

Reason (R): A matched termination absorbs all the power incident on it.

View solution

Q. Skin effect is more pronounced at high frequencies.

View solution

Q. Assertion (A): The phenomenon of differential mobility is called transferred electron effect.

Reason (R): GaAs exhibits transferred electron effect.

View solution

Q. Which of the following devices uses a helix?

View solution

Q. The action of backward wave oscillator is similar to that of

View solution

Q. Assertion (A): Artificial transmission lines are frequently used in laboratories.

Reason (R): An artificial transmission line can be used to represent an actual line and can also be used as a delay circuit, as attenuator, as filter network etc.

View solution

Q. In a backward wave oscillator the wave travelling along the line winds itself back and forth

View solution

Q. A line is excited by a 100 V dc source. If reflection coefficients at both ends are 1 each then

View solution

Q. A line has Z0 = 300 ∠ 0° Ω. If ZL = 150 ∠ 0° Ω, reflection coefficient is

View solution

Q. Assertion (A): A backward wave oscillator has an internal positive feedback.

Reason (R): A positive feedback is necessary for sustained oscillations.

View solution

Q. In a microstrip transmission the signal can be easily redirected by changing the centre strip.

View solution

Q. The frequency of oscillation in a backward wave oscillator can be changed by

View solution

Q. A line has a phase constant of 29.8 rad/m. At 1000 MHz the wavelength is

View solution