Q. In a microstrip transmission the signal can be easily redirected by changing the centre strip.

View solution

Q. The frequency of oscillation in a backward wave oscillator can be changed by

View solution

Q. A line has a phase constant of 29.8 rad/m. At 1000 MHz the wavelength is

View solution

Q. In a directional coupler

View solution

Q. As the frequency is increased, the charging MVAR in a cable

View solution

Q. Loss angle of a good quality cable is about

View solution

Q. In a three cavity klystron amplifier, the oscillations are excited in

View solution

Q. Assertion (A): A coaxial line is a non-radiating line.

Reason (R): In a coaxial line the electric and magnetic fields are confined to the region between the concentric conductors.

View solution

Q. Reflex klystron oscillator is essentially a low power device

View solution

Q. A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is

View solution

Q. A matched generator (Zg = Z0) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are

View solution

Q. Which TM mode in rectangular waveguide has lowest cutoff frequency?

View solution

Q. The velocity factor of a transmission line depends on

View solution

Q. A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is

View solution

Q. In a klystron amplifier the input cavity is called

View solution

Q. In a circular waveguide the dominant mode is

View solution

Q. The reflection coefficient on a line is 0.2 ∠45°. The SWR is

View solution

Q. For a 50 Ω resistor for 3 GHz application, the stray capacitance should be less than

View solution

Q. In a travelling wave tube distributed interaction between an electron beam and a travelling wave takes place

View solution

Q. The fabrication of microstrip line is done by

View solution