Question

Which of the following devices uses a helix?

a.

Klystron amplifier

b.

Klystron oscillator

c.

TWT

d.

Both (a) and (b)

Answer: (c).TWT

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Which of the following devices uses a helix?

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The action of backward wave oscillator is similar to that of

Q. Assertion (A): Artificial transmission lines are frequently used in laboratories.

Reason (R): An artificial transmission line can be used to represent an actual line and can also be used as a delay circuit, as attenuator, as filter network etc.

Q. In a backward wave oscillator the wave travelling along the line winds itself back and forth

Q. A line is excited by a 100 V dc source. If reflection coefficients at both ends are 1 each then

Q. A line has Z0 = 300 ∠ 0° Ω. If ZL = 150 ∠ 0° Ω, reflection coefficient is

Q. Assertion (A): A backward wave oscillator has an internal positive feedback.

Reason (R): A positive feedback is necessary for sustained oscillations.

Q. In a microstrip transmission the signal can be easily redirected by changing the centre strip.

Q. The frequency of oscillation in a backward wave oscillator can be changed by

Q. A line has a phase constant of 29.8 rad/m. At 1000 MHz the wavelength is

Q. In a directional coupler

Q. As the frequency is increased, the charging MVAR in a cable

Q. Loss angle of a good quality cable is about

Q. In a three cavity klystron amplifier, the oscillations are excited in

Q. Assertion (A): A coaxial line is a non-radiating line.

Reason (R): In a coaxial line the electric and magnetic fields are confined to the region between the concentric conductors.

Q. Reflex klystron oscillator is essentially a low power device

Q. A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is

Q. A matched generator (Zg = Z0) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are

Q. Which TM mode in rectangular waveguide has lowest cutoff frequency?

Q. The velocity factor of a transmission line depends on

Q. A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!