Q. Ferrites are

View solution

Q. High purity copper is obtained by

View solution

Q. Photo electric emission can occur only if the frequency of light is more than threshold frequency.

View solution

Q. In a JFET the width of channel is controlled by

View solution

Q. The unit of thermal resistance of a semi-conductor device is

View solution

Q. No load d.c. output will be least in case of

View solution

Q. When an electron breaks a covalent bond and moves away,

View solution

Q. A photo diode is

View solution

Q. Germanium and Si phosphorus have their maximum spectral response in the

View solution

Q. In which condition does BJT behave like a closed switch?

View solution

Q. The primary reason for the widespread use of Si in semiconductor device technology is

View solution

Q. If the conductivity of pure germanium is 1.54 siemens/metre, its resistivity in ohm-metre will be nearly

View solution

Q. Reluctivity is analogous to

View solution

Q. The v-i characteristics of a diode may be linear or non linear.

View solution

Q. If a coil has diameter 'd' number of turns 'N' and form factor F then the inductance of the coil is proportional to

View solution

Q. Lowest resistivity of the following is

View solution

Q. Peak inverse voltage will be highest for

View solution

Q. In CE configuration, the output characteristics of a bipolar junction transistor is drawn between

View solution

Q. Assertion (A): The reverse current in a p-n junction is nearly constant.

Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.

View solution

Q. An n type semiconductor is illuminated by a steady flux of photons with energy greater than the band gap energy. The change in conductivity Δσ obeys which relation?
[ Here, e is the electron charge, μn electron mobility, μp hole mobility, Δn (Δp) is the excess electron (hole) density ].

View solution