Q. Peak inverse voltage will be highest for

View solution

Q. In CE configuration, the output characteristics of a bipolar junction transistor is drawn between

View solution

Q. Assertion (A): The reverse current in a p-n junction is nearly constant.

Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.

View solution

Q. An n type semiconductor is illuminated by a steady flux of photons with energy greater than the band gap energy. The change in conductivity Δσ obeys which relation?
[ Here, e is the electron charge, μn electron mobility, μp hole mobility, Δn (Δp) is the excess electron (hole) density ].

View solution

Q. The band gap of Si at room temperature is

View solution

Q. Spot the odd one out

View solution

Q. Transition capacitance is associated with __________ and depletion capacitance is associated with __________ diodes.

View solution

Q. If the energy gap of a semiconductor is 1.1 eV, then it would be.

View solution

Q. The maximum rectification efficiency in case of full wave rectifier is

View solution

Q. For a full wave bridge rectifier supplied with 50 Hz a.c., the lowest ripple frequency will be

View solution

Q. When an electron rises through a potential of 100 V it will acquired an energy of

View solution

Q. Which one of the following gain equations is correct for a MOSFET common-source amplifier?

(gm is mutual conductance, and RD is load resistance at the drain)

View solution

Q. If 1 kVA transformer is used for all of the following rectifiers, the d.c. power availability will be least in case of

View solution

Q. In which of the following does a negative resistance region exist in the v-i characteristics?

View solution

Q. The intrinsic resistivity of silicon at 300 K is about

View solution

Q. What happens when forward bias is applied to a junction diode?

View solution

Q. A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.

View solution

Q. The addition of impurity in extrinsic semiconductor is about 1 part in 10⁸ parts.

View solution

Q. It is required to trace the output characteristics of a CE bipolar transistor on a CRO screen. The proper method is

View solution

Q. Atomic number of germanium is

View solution